Dental Alginate Mixer WWG-339
Voltage 220 V / 50 Hz(110 V / 60 Hz are available)
Frequency 400 W
Mixing frequency 3000 tr / mn ( cpm )
Dimensions 205 x245x 295 MM
Gross weight 16Kg
1. Adopt imported actuator: lower noise and longer service life
2. Microcomputer control, safe and reliable operation
3.After stirring, it can produce impression material without bubbles, good elasticity, not easy to deformation, modulus more clearly;
4. Time setting range is between 1-24 seconds by the user, according to different impression material characteristics to choose;
5.According to user needs, there are three computer memory setting ( default setting is 8 seconds” scoop of powder”,10seconds two scoop of powder,”12 seconds” three scoop of powder” );
6.Internal temperature can be controlled, which make it possible that work continuously for a long time without affecting the impression material production;
The following items should be noted closely to assure smooth operation, which is helpful to free from the accident of personal injure:
1.In order to extend the setting time of alginate impression material while in mixing, please use cool water(10℃~20℃).If desires to use the fast-setting alginate it should specifically watch the setting time.
2.In order to avoid any malfunction, if the mixing bowl has not been closely tight with cap, the machine shall not be stared. If only water is contained, the mixer shall not be started.
3.The limited weight of mixing on each capacity is25g~100g, never exceeds 100g.
4.Since the possible leakage might be occurred on mixing bowl while it is running, so it only can be used in the tightened state.
5.If the small hole at the enter of mixing bowl cap is jammed, which would cause difficulty on tightening. The jam of small hole shall be removed immediately if it was jammed.
6.If there is any abnormal noise or vibration while in the mixing, the STOP button shall be pressed immediately. The lift the cover to check if any disorder condition happened.
7.The mixing bowl is the consumed product of accessories, if it can not be covered tightly due to transformation, please change a new one.
8.If the machine is to be sent for repair or delivered to a far place, please fasten the motor by two fixing bolts attached for handing. Otherwise, it will cause a more serious problem